Machining & Metrology Unit

The completed project - Mini Lathe

The angular surface of the Cross Slide Grip (LA040202) is being cut by using a
Vertical Milling Machine which milling head is set an angle 30 degree from vertical

Raw material of the Saddle (LA040100) is mounted on a 'MECATOOL' Pallet
and is being cut by using a Vertical Milling Machine

Bush housing of the Saddle (LA040100) is being bored by using a
Boring Head attached in a Vertical Milling Machine

Tailstock Spindle (LA030200) is clamped in a 3 jaws chuck of the Centre Lathe and
supported by a tailstock centre as well as being cut by using a Right Hand Side Turning Tool

Spindle Pulley (LA010203) is cut by using a Right Hand Side Turning Tool in the Centre Lathe

A 8.5 mm hole of the Tailstock Spindle (LA030200) is drilled by using the
Centre Lathe and cutting fuild is applied

A Face Milling Cutter cut the datum surface of the Headstock (LA010100)
which is mounded on an Angle Plate attached on the Vertical Milling Machine

The flat surface of the Rear Base (LA020100) has been cut by a
Face Milling Cutter equipped in a Vertial Milling Machine

You are here: Home > Integrated Training Project > Photos Gallery
	Integrated Training Project - Photos Gallery
	The completed project - Mini Lathe The angular surface of the Cross Slide Grip (LA040202) is being cut by using a Vertical Milling Machine which milling head is set an angle 30 degree from vertical Raw material of the Saddle (LA040100) is mounted on a 'MECATOOL' Pallet and is being cut by using a Vertical Milling Machine Bush housing of the Saddle (LA040100) is being bored by using a Boring Head attached in a Vertical Milling Machine Tailstock Spindle (LA030200) is clamped in a 3 jaws chuck of the Centre Lathe and supported by a tailstock centre as well as being cut by using a Right Hand Side Turning Tool Spindle Pulley (LA010203) is cut by using a Right Hand Side Turning Tool in the Centre Lathe A 8.5 mm hole of the Tailstock Spindle (LA030200) is drilled by using the Centre Lathe and cutting fuild is applied A Face Milling Cutter cut the datum surface of the Headstock (LA010100) which is mounded on an Angle Plate attached on the Vertical Milling Machine The flat surface of the Rear Base (LA020100) has been cut by a Face Milling Cutter equipped in a Vertial Milling Machine